Peugeot 308 Key Fob: The Good The Bad And The Ugly

peugeot 208 key programming 308 Key Fob Replacement

Peugeot's 308 might seem somewhat old-fashioned but it's eye-catching. It's not the most luxurious vehicle in its class, but it is a pleasant and peaceful drive.

We often receive requests from Coded Car Keys to replace peugeot key fobs. The following tips will aid whether the issue is intermittent, or constant.

Water Damage

If you accidentally drop your key fob in a puddle or it is wet while kayaking, canoeing, rafting, or canyoning it is likely to be damaged by water. Keep your key fob in a dry bag every time you go outdoors or do activities that could expose it to large amounts of water.

It's also crucial to make sure that the fob has dried out prior to opening it up and then use it again. If you notice any odors coming from the fob, such as an industrial-type liquid smell or windshield washer fluid, it's another indication that it's been submerged in water.

A wet circuit could cause the battery's energy to drain or even explode. If you can get your keyfob 308 from the water and turn it upside up and shake as much water out as you can before opening the casing. Remove the battery, then clean the circuit board with a cotton swab that has been dipped into 90-percent alcohol.

Other reasons your peugeot expert key, linked site, 308 remote entry keyless system might not function include a dead battery in the coin-cell or receiver module malfunction, signal interference or a malfunctioning chip. If none of the above are the issue, try resetting the system by disconnection of the battery with 12 volts for about 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote-start system that allows the driver to start the car from a distance, warming up or cooling down the vehicle prior to stepping inside. This feature is very useful, especially in the cold winter months. However, sometimes the remote start system stops functioning due to a variety of reasons, such as a dead coin battery.

A coin-shaped battery that is located inside the key fob can last for a period of two to four years, depending on how often used and where it is purchased. Its use-by date is typically found on the packaging or listed in the instruction manual.

If the key fob has stopped working after exposure to pure tapwater, you need to remove the battery and clean the electronic chip using an absorbent paper towel that has been soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing it. If you expose it to soapy or salty water, the chip may be fried and you will need to replace the key fob in total.

If you're not certain that the battery is not working properly it is possible to test its voltage with a multimeter that is set to the car's voltage range, and connect it to the terminals for minus and plus. If the voltage is less than 12-13 volts you need to replace the battery. You can also reset the computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should now begin.

Faulty Receiver Module

If you're not getting the "Key Detected" message on your dashboard, it's possible the receiver module has developed a fault. It's the part that sends an alert to the car when your key fob is activated it also acts as an immobiliser. It stops it from starting until the correct key is used.

This could result from a variety of reasons, including water damage or simply getting old. If the electronic chip within your Peugeot 308 keyfob has been damaged by dirty tap water, it could be because the keyfob was exposed it. In this scenario, you'll have to take it off and thoroughly clean it with isopropyl or an electronic cleaner. Once it's dry you can put the battery back in and try again.

If the issue continues to persist, it is a good idea that you visit a local peugeot 406 remote key programming expert or locksmith. They can employ an instrument for diagnosing to pinpoint the issue and then fix it.

It can be stressful to lose your Peugeot car key. However, a reputable auto locksmith can address the issue in only a few minutes. They can program your vehicle and cut a fresh, working key for you. Find locksmiths near you.

Faulty Electronic Chip

The electronic chip inside your peugeot 108 key cover 308 key fob is a very crucial component of the remote control system. If it gets damaged, your car may not start, or you could receive a message saying "anti-theft active". In this situation the only option is to replace the key. Auto locksmiths with experience can provide this service within the shortest possible time.

The chip in the key fob of your peugeot 207 remote key programming 308 could fail due to various reasons, including sweat, water damage or dirt. If your Peugeot 308 key fob is exposed to soapy water, you must clean it immediately. You can clean the electronic component using an absorbent paper towel that has been soaked in isopropyl Alcohol. The battery should then be allowed to dry completely.

Sometimes keys can cease to function due to radio interference. This can be caused by other devices that operate on the same frequency as your Peugeot key fob. It can also be caused by weather conditions or objects around the vehicle. If you have this issue it is recommended to visit a Peugeot dealership.

The Peugeot 207/308 key fob is very delicate and requires special attention. You should not drop it or throw it around. If you lose something, try to find it as soon as possible. You can reset your on-board computer by disconnecting the battery for a couple of minutes. Disconnect the negative cable prior to the positive.